Miss Elam 1/12 Brushless Hydro
Prodotti simili
With speeds normally reserved for nitro boats and the simplicity ofbrushless electric power, the Miss Elam Brushless RTR brings a wholenew level of ease to the RTR segment. Pro Boat’s powerful brushlesselectric motor propels the Miss Elam BL to speeds that rival therecord-holding full-size boat, and Pro Boat’s unique magnetic hatchallows quick and easy access to the electronics while protecting themfrom the elements. The authentic hydro hull is handcrafted fromfiberglass and utilizes an offset rudder that provides precise,predictable handling.
Completely ready-to-run withwater-cooled brushless motor, programmable electronic speed control andradio system installed, the Miss Elam Brushless is an incrediblydetailed and realistic boat that takes radio control excitement to thenext level.
The Miss Elam is built under license from Ellstrom Manufacturing.
Needed to Complete
- 8 AA alkaline batteries for the radio transmitter
- 7.2V Ni-MH Battery Pack with Deans connector (PRB3313 or PRB3314) (2)
- Twin Peak Dual Battery Charger (DYN4033)
- Tamiya/Deans adapter (PRB3312)
- Officially licensed from Ellstrom Manufacturing
- Powerful, water-cooled brushless motor for intense speed
- Extended flex shaft drive system
- Water-cooled brushless ESC offers unsurpassed reliability
- Waterproof quick-access radio compartment
- Magnetic hatch allows easy and secure access to batteries and electronics
- Pro Boat® 2-channel AM pistol-grip radio installed
Needed to Complete
- 8 AA alkaline batteries for the radio transmitter
- 7.2V Ni-MH Battery Pack with Deans connector (PRB3313 or PRB3314) (2)
- Twin Peak Dual Battery Charger (DYN4033)
- Tamiya/Deans adapter (PRB3312)
- Length: 27.5 in (699mm)
- Beam: 14 in (356mm)
- Motor Size: A3630-1500 Water-cooled brushless
- Radio: Pro Boat pistol-grip 27MHz AM (installed)
- Hull Material: Fiberglass composite
- Hull Type: Hydroplane
- Kit/RTR: RTR
- Scale: 1/12
- Drive System: Direct-drive, flex shaft
- Recommended Environment: Outdoor
Needed to Complete
- 8 AA alkaline batteries for the radio transmitter
- 7.2V Ni-MH Battery Pack with Deans connector (PRB3313 or PRB3314) (2)
- Twin Peak Dual Battery Charger (DYN4033)
- Tamiya/Deans adapter (PRB3312)
Tech Notes
Due to the high current rates associated with brushless electric boats, ProBoat recommends using batteries with an ability to discharge at a minimum of 25 amps (25C). The DYN5360D (Li-Po) or PRB3313 or PRB3314 (Ni-MH) are good choices with matched cells and quality chemistries.
Lower quality batteries cannot maintain a high enough average voltage to keep the electronic speed control from entering the low voltage cutoff mode. This safety feature protects the batteries and ESC from damage.
A programming module (PRB3311) is required to change the programming of your speed control in order to use Li-Po Batteries.
The ESC in your Miss Elam Brushless is preprogrammed from the factory. The programming is set for Ni-MH batteries as shipped with your Miss Elam.
The programming module (PRB3311) is available separately to change the programming of your speed control. Settings include Ni-MH or Li-Po batteries, cutoff voltage settings, cutoff type, brake on or off, motor timing and throttle curve. Caution: It is imperative that you do not attempt to use Li-Po batteries in the Miss Elam Brushless unless it has been properly programmed or serious damage to the batteries and electronics may occur.
